Worked well on my 2018 Yamaha Grizzly

The Warn website wasn't clear if it was the right part, one page said through '19, another said through '21.It fit my '21 just fine. Instead of holding the plate up and marking the hole, I found this process much easier.Start with the rear holes by the foot peg brackets. The plastic guard on the ATV measures 14 3/4"" across. The inside of the two holes on the plate are 11 5/8"". So about 3"" difference. Measure in 1.5"" from the outside on each side of the plastic guard. Then drill the holes. The U bolt drops right through. Tighten up the nuts on both sides.Then drill holes in the plastic guard for the front U bolts through the holes that are in the plate. Much easier than trying to hold and guess where holes should go.It took me about 30 minutes to install, but would only take about 15 now that I figured out how to do it by measuring first.

Works great for mounting plow but not as big as the skid plate I had to take off. I'll have to make another skid plate to protect the rest of the bottom of the engine.

Perfect for Yamaha Kodiak 700.

High quality construction. Easy to install.

Bought this for our atv and plow. Super easy to install, no real issues. We were able to modify it on the right side. Not to heavy or thick. Worked perfectly for our first snow. Really recommend this product.

Great product

works great!!!!

Everything as expected. Very heavy duty unit with everything fitting as expected. Installation is not too bad. I would recommend that it be test fitted by holding it up where it will go to ensure the placement is good and the u-bolts will go around the frame without causing other issues. In my case I removed a couple of the skid plate bolts so I could pull it down enough to ensure the placement was going to be good.

Worked great.