The wiring harness is wrong. When I opened the driver door the passenger steps would drop down and vice-versa. I had to move the orange and white cables. Had to splice them as I couldn't get the pins out. The lights where correct.

The media could not be loaded. Installation was a breeze on my 15 F250 crew cab.. running boards are out of control, very nice

Installation was not bad, the electrical diagram could be a lot better for the price you pay

They are great, but they were wired wrong, had to call support to find out what was wrong

Great product

Installation was pretty straight forward. The wiring harness seems off. I did do the LED lights and drilled holes in my truck. I sprayed some clear coat on the holes to help lower the chance of rusting. The drivers side harness fits reasonably well but I would still like a few more inches for slack. The Xtreme version is supposed to be for mud and snow, but I don't like how the wires are pulled away from the body where snow or mud could build up and pull on the wires. I had to switch the wires at the gray motor plug because the ramps did the opposite, open the door and the ramp retracted and close the door and it went out (Use a small pick on a tab at the tip of the plug to release the wires. I had to switch orange from the left to the right side of plug). I also had to add jumper wires 3"" for the front and 12"" for the back to lengthen the LED power supply wires, but only on the passenger side. AMP Research answered the phone right away (real person, not a robo menu) and talked me through it. Having to rewire the motors and the overall short length of the harness is why I pulled a star.

Installed on my f350 and while everything seems good quality, the wires for each side should be about 6 inches longer so wiring is able to be tucked tighter to the body and isn't as tight. I also had to make 8"" extensions for the led light as they were short for were instructions said to mount. The other issue was as others have reported, after install the wiring was backwards. These aren't cheap steps and shouldn't have to make extensions and rewire for what they cost.

Great product. Install was simple with no issues.

Nice kit, quality material original impression. Installation went smooth with exception that the motors were wired backwards. Contacted Mfg and the problem was resolved. I had a local garage do installation. Installed a OBD 2 splitter to enable gauge use with steps. Choose not to install puddle lights as I did not want to drill holes in the truck. Works fine so far.