DuroBumps are quality made in the USA with dual durometer (hardness) rubber, to deliver smooth, progressive dampening that reduces hard bottom-outs significantly and allows for greater control and comfort. OEM bump stops tend to feel rock-hard on contact. DuroBumps eliminate that hard bump.
The DuroBumps DBF24RPU is slightly taller than OEM bump stops because the DuroBumps compresses under load to lessen the impact just before the ultimate stop. The DBF24RPU will not limit your wheel-up travel.
It's designed to replace the rear-mounted OEM bump stop on the front passenger and driver sides of the truck.
The DBR24RPU is the only aftermarket bump stop designed with a 14 degree taper, ensuring even contact upon engagement.
Note: DBF24RPU includes the required nut and bolt needed to mount the front DBF24RPU Durobumps to 1989 - 1995 Toyota Pickup trucks only.
Features and Benefits:
- Better handling - Dual durometer (hardness) rubber allows DuroBumps to act as secondary coil springs, increasing the compression load progressively in a smooth, predictable fashion.
- 14 degree angle - With trucks' bump stops being mounted to the lower control arm, the bump stop doesn't contact the strike pad squarely. This causes shearing and damages the bump stop. DuroBumps' 14 degree angle addresses the shearing issue by ensuring square, even contact.
- Mounts in OEM location - DuroBumps easily bolt into the OEM mounting location, ensuring a proper fit with no modifications.
- No loss of up-travel - DuroBumps will not reduce your suspension/wheel travel.
- Increased suspension life - DuroBumps greatly extends the service life of the other suspension components by absorbing the shock load and helping prevent bottom-outs. DuroBumps protects your critical suspension components from excessive wear and extends service intervals for your shocks, ball joints, and control-arm bushings.
- Reduced bump steer - By absorbing the suspension's up-travel inertia, DuroBumps greatly reduce the energy applied through the tie-rod ends and steering rack, reducing shock load and wear and tear on inner and outer tie-rod ends, steering rack, and steering rack bushings.
- Small, compact, application specific - Designed for specific truck models. No universal fit spacers required.
- Smooth and silent - Unlike Hydro bumps, DuroBumps are whisper-quiet on contact.
- Solid mounting base - A 3/16 inch steel base plate ensures solid mounting and strong support for DuroBumps. The base plate is powder-coated to help prevent corrosion.
- Provided mounting hardware - Every set of DuroBumps comes with JIS 10.9 zinc-coated hex-head metric bolts and single-use thread locker, ensuring a strong, secure fit.
- Premium bump stops - DuroBumps are proudly made in the USA from the highest quality raw materials. You won't find a higher quality bump stop anywhere.
What's Included:
- (2) Two front DuroBumps
- (2) Two JIS 10.9 M10 1.25 mm x 35 mm flange bolts
- (2) Two JIS 10.9 M10 1.25 mm x 35 mm flange nuts
- (1) Single-use medium thread locker
- (1) One FREE sticker