The rebuild kit was easy to install the other factor is its high angle collar for lifted Jeeps gives you peice ofind that you won't have a failure of the rubber boot it's also more affordable than buying the high dollar aftermarket driveshafts will see how long this lasts my original one was twelve years old before failure definitely recommend this product

Worked great on my jeep with 2.5"" lift. Easy to install as well.

Came with the special tool to use with it which is amazing, and everything else needed. Good and correct product.

So far so good installed this after I installed 1 from Advance auto that only lasted 2 months and less than 3k miles.

The product itself is as advertised. This was the first one that I have replaced so I was my own worst enemy during the installation process. The original joint didn't come off easily and I ended up using heat and a gear puller to get it off. The new one required a large socket and hammer to get it installed on the shaft. Other than that, it was a pretty easy process.

Works well fairly easy to install with some time. Had some trouble getting it to seat all the way and would have prefured a different style snap-ring. Way more clearance fully extended it doesn't rub at all. Installed on a 2012 jeep wrangler jku with 35's and a 4"" lift

Just installed today, hope it works out. I'll edit in a few months if it goes out!

Was told my drive shaft needed to be replaced due to a broken CV joint.Did some research and found this.Install was straight forward and it works as it should and I saved money by not needing a driveshaft.

The boot on my front axle wore through and was making noise in 4 wheel drive. This was easy to replace took about an hour start to finish. There is more clearance from the driveshaft them OEM. Make sure you pack the bearings with all the grease provided. Its been installed for a couple of months no issues. Went off road the other day no issues working well so far.